ST225 Motorsport S10 Driveshafts
A brand new design of motorsport driveshafts, superseding the previous S9 design with various new arrangement of materials and layouts for superiority of strength. A true ‘end product’ of continuous development and innovation. CPS M-sport Driveshafts are engineered to the highest possible standard. They are designed to have superior strength, tolerance, and reliability over the OEM shafts. Ideally suited for high power conversions, fast road conditions and track day use.
It is common knowledge that the OEM driveshafts fitted to the Ford Focus ST225 can be delicate and easily damaged when used in a spirited manner. They suffer from regular CV boot failure and in extreme cases the have been known to shear when used on Track. To tackle these common problems , CPS have applied their Extensive Vehicle knowledge and Automotive Engineering skills to develop an “off-the-shelf” Motorsport grade driveshaft for the Ford Focus ST225 to eradicate all known common faults associated to the OEM shaft.
The M-sport shafts are a direct replacement for the OEM driveshafts; no modifications are required to fit them to your car, they are the perfect addition to modified and un-modified ST225s. They offer superior strength and reliability weather your car is standard, lightly modified or Heavily modified without compromising the factory ride quality.
The CPS m-sport Driveshafts have been extensively tested on the Bench, on the Road and on Track, the driveshaft is constructed from High tensile Steel that has been heated treated to add to their already impressive strength, when fully assembled and tested they have been proven to be over Five times as strong as the OEM shafts*.
Due to the nature of this set up you may feel some feedback through the drive train which is characteristic of any Motorsport grade product. However with the Motorsport balanced shaft the feel of the driveshaft is similar to OEM but with Motorsport strength, versatility and reliability!
The Motorsport drive shafts are well refined, and are solid and a smaller diameter which offers better balance, lighter weight and less feed back through the drive train. This is ideal for finely set up and tuned track cars, as well as standard cars.
- HIGH SPEED BALANCED DRIVESHAFTS BARS
- SOLID MAIN SHAFT DESIGN FOR SMOOTHER OPERATION
- ENGINEERED FROM HEAT TREATED, HIGH-TENSILE, MOTORSPORT GRADE STEEL
- UPGRADED, HIGH TENSILE, MOTORSPORT GRADE STEEL INBOARD CV CUPS
- UPGRADED AND ENLARGED INBOARD CV TRIPODS
- UPGRADED, HIGH TENSILE STEEL O/S INNER SHAFT EQUIPPED WITH A HIGH SPEED BEARING
- UPGRADED AND ENLARGED “6 BEARING” OUTER CV JOINT
- UPGRADED THERMOPLASTIC OUTER CV BOOT
- UPGRADED AND RESIZED NEOPRENE INBOARD CV BOOTS
- MOTORSPORT GREASE IN ALL CV JOINTS
- PRICE ADVERTISED IS FOR A COMPLETE PAIR (1 X SHORT & 1 X LONG DRIVESHAFT)
These drive shafts are a simple direct replacement for the OEM ones and fit in the exact same manner. Ensure when fitting the Motorsport shafts, you pull the splined end of the shafts all the way into the hub. Before fitting the new shafts clean the inner hubs where the female spline section is with a wire brush to remove all debris, and use a gentle lubricant to ensure the new shafts go into the hub as far as the OEM ones did. These new drive shafts have a much finer tollerance and need to be drawn into the hub, they wont just slide all the way in, this allows greater strength and alleviates the annoying clicking noise made by many oem shaft splines. Do not use Locktite on these shaft splines!!!!
Please allow 48 Hours after ordering your shafts for them to be assembled, balanced & inspected prior to dispatch.
PLEASE NOTE: THIS ITEM MAY BE SENT TO YOU DIRECTLY FROM DREAMSCIENCE IN THE UK PENDING CURRENT STOCK.